An example of output returned by this command is: rscadm version RSC version v2. Using -v provides more information about RSC, as shown in the following example:. Same as the version -v command; available on all supported servers. To administer user accounts from the host using rscadm , log in to the host as root and use the rscadm utility with the following subcommands:. The last 12 messages are usage error messages. During execution of the userpassword subcommand, you enter the password twice.
If passwords do not match, you are prompted to enter them again. This error occurs if you try to add a user account when RSC already has the maximum number of accounts configured.
RSC supports only 16 user accounts 4 on the Sun Enterprise servers. You must delete an account before you can add another. You used an invalid rscadm subcommand. Perhaps the modem is not connected or is currently being used by the paging subsystem. RSC detected an internal error while trying to set the date.
RSC encountered an internal error when trying to add a user account. RSC encountered an internal error when trying to change a user password. RSC encountered an internal error when trying to change user permissions.
RSC encountered an internal error when trying to delete a user account. RSC encountered an internal error when trying to access user information during a usershow subcommand. You cannot execute the download subcommand when the server keyswitch is in the Lock position. An internal error occurred during execution of the download subcommand. If they do not match again, the subcommand fails. During execution of the download subcommand, the rscadm utility could not open the file specified on the command line.
During execution of the download subcommand, the file to download is not a valid s-record file. This is an internal rscadm software error. Alternatively if a more persistent solution is required you can set the individual OBP variables back to the defaults: ok setenv diag-out-console false ok setenv input-device keyboard ok setenv output-device screen If access to Solaris and the RSC card is not available as a last resort the RSC card can be removed.
Spread a word. December 12, at am. Teodoro Phillis says:. April 28, at am. Yogesh Raheja says:. April 30, at am. July 7, at am. Solaris Hardware Reference Center unixadminschool. I have switched the key to diag mode, and the output follows.. The last line is where it stops, and just sits.. I am looking for any ideas.. With some console switches, when the server has been rebooted the console session hangs and you have to close the session on the switch and start a new one.
Follup up - The problem turned out to be OBP configuration errors, after I managed to get to the ok prompt, I was able to correct the problems, set it to boot to cdrom, and pop in the install cd.. How I got TO the ok prompt was a trick, and I was able to reproduce it.. Red Flag This Post Please let us know here why this post is inappropriate.
In most cases the erroneous fault does not reappear. You can verify the disk after the boot process by using the fsck utility. Any disk drive error message reported by the Solaris operating environment is a real disk drive error. If a disk fault is reported at the ok prompt and the system fails to boot to the Solaris operating environment, there may be a problem with the disk drive.
After a cold restart or after powering on the system, the RSC command rscadm resetrsc fails; this is a known condition.
0コメント